Installation (DigiMOTOR Reflex)

Da SmartSystem Wiki.

Overview

The motor installation kit needs to mount a specific bracket. This bracket grants an ultra fast installation and removal of the whole kit, completely tool free

Carriage to Motor Bracket Installation

Thanks to the dedicated hex key, remove the carriage fixing screw on the right side.

Wiki digimotor reflex install 01.JPG

As you can see, the additional hex screw supplied (on the right of the following picture) is just a little bit longer.

Wiki digimotor reflex install 02.JPG

Take the carriage to motor bracket and install on the carriage. The fixing hole of the bracket must be aligned with the hole left empty from previous screw removal.

Wiki digimotor reflex install 03.JPG

After bracket installation, fix its position to the carriage using the TSPCEI M5x20 screw using the appropriate hex key (both supplied with DigiMOTOR Reflex kit).

Wiki digimotor reflex install 04.JPG

Now you can easily install the DigiMOTOR Reflex simply locking it position on the bracket with the knurled knob supplied.

Wiki digimotor reflex install 05.JPG

40px THE MOTOR TO CARRIAGE BRACKET WAS DESIGNED TO LET YOU INSTALL EVERY FLAT PLATE HEAD WITHOUT INTERFERENCES.


Our technical department is on tap for any information about it.

Motor Installation

In order to install the motor assembly, you need no specific tools thanks to its completely tool free design.

Wiki digimotor reflex install 06.JPG

You have to place your SmartSLIDER Reflex on a clean and flat surface, first.

DigiMOTOR Reflex has a special no stretching belt supplied. Looking the Motor assembly in a way you can read the CE mark, take the belt positioned on the down left side, as shown in the picture

Wiki digimotor reflex install 07.JPG


Tilt slightly the motor assembly and let the main motor assembly became completely surrounded by the carriage to motor bracket.

Wiki digimotor reflex install 08.JPG

Lock in position the motor with the supplied knurled knob interjecting the nylon washer between the knob and the bracket. This little trick prevents the natural wearing of the surface of the bracket and grants an optimal grip action.

Wiki digimotor reflex install 09.JPG


Belt Installation

With the motor installed on the carriage, you can go on with the belt fixing.

Wiki digimotor reflex install 10.JPG

In order to properly install the belt of you DigiMOTOR Reflex, it will be sufficient to let the belt pass through the splits placed in both of the lateral supports of your SmartSLIDER Reflex.

Wiki digimotor reflex install 11.JPG

To lock the belt in position, simply verify that the hollow between two belt theeth corresponds with the external split edge of the lateral support. Lock in position using the fixing washer supplied with DigiMOTOR Reflex and with the knurled knob supplied with the SmartSLIDER Reflex.

Wiki digimotor reflex install 12.JPG

You can repeat the same procedure on the other side.

Wiki digimotor reflex install 13.JPG

Before locking the belt on the other side with the supplied washer, make sure to tension enought the belt choosing the right hollow between belt teeth.

Wiki digimotor reflex install 14.JPG

Congratulations, you properly installed the DigiMOTOR Reflex on your SmartSLIDER Reflex. You should obtain a situation like the one represented on the following picture

Wiki digimotor reflex install 15.JPG

40px ALWAYS VERIFIY THAT BRAKE AND DRAG ARE NOT ENGAGED BEFORE STARTING A WORKING SESSION WITH YOUR MOTORIZED SLIDER.